3d Laser Engraving Machine
The reset is abnormal: 1. Check the 3D Laser Engraving Machine sensor for dust, poor contact, or damage (clean the dust on the sensor or replace it); 2. Check whether the flexible conductive tape data cable has bad contact or is damaged (trim the data cable again Unplug or replace the data cable); 3. Check whether the ground wire contact is reliable or the high voltage wire is damaged (reground or replace the high voltage wire); 4. The motor wire is not in good contact. 1. The initialization is incorrect and the data has been sent (corrected); 2. The operation order is reversed (re-output); 3. Static interference (check whether the ground wire has fallen off).
Clean the edge of the hook, not closed: 1. Whether the edited file is correct (re-editing); 2. Whether the selected target is over the publishing surface (re-selecting); 3. Check whether the software parameter settings are correct (re-setting); 4. Computer System error (reinstall laser engraver operating system and software); 5. Check if the left and right belts are consistent or the back-end belt is too loose (belt tightening); 6. Check whether the belt or timing wheel is slipping or jumping (tighten the timing wheel) (Or belt); 7. Check whether the beams are parallel (readjust the left and right belts). The computer cannot output: 1. Check whether the software parameter settings are normal (reset); 2. Whether the engraving machine is started by positioning and then output (re-output); 3. Check whether the machine has not been reset beforehand (re-correct 3D Laser Engraving Machine); 4. Check whether the output serial port is consistent with the software setting serial port (reset); 5. Check whether the ground wire is reliable and whether static electricity is interfering with the data cable (regrounding); 6. Replace the computer serial port output test; 7. Reinstall the software and reset Test; 8. Format the computer system disk and reinstall the software test; 9. The motherboard serial port is damaged and needs to be repaired or replaced.