Wood Laser Engraving Near Me
The laser head does not emit light. Press the test button on the operation panel to observe the status of the Wood Laser Engraving Near Me current meter: ① No current: Check whether the laser power supply is turned on, whether the high-voltage line is loose or detached, and whether the signal line is loose; ② There is current: check whether the lens Whether it is broken or the light path is severely shifted; 2. Check whether the water circulation system is normal: ① No water flow: Check whether the pump is damaged or no power; ② Water flow: Check whether the water inlet and outlet are reversed or the water pipe is broken; Can self-test, sending data does not glow (check if the computer settings are correct).
Laser engraver engraving in different depths or depths: 1. Check whether the water flow in the water circulation system is smooth (bent or broken pipe); 2. Check whether the focal length is normal (recalibration); 3. Check whether the optical path is normal (recalibration); 4. Check whether the paper on the plate is too thick and the water is too much (re-correct); 5. Check whether the beam is parallel (adjust the two sides of the belt); 6. Check whether the lens is broken (replace); 7. Check the lens or laser tube Whether the transmitting end is contaminated (recleaned); 8. Check whether the water temperature is higher than 30 ° C (replace the circulating water); 9. Check whether the laser head or focusing lens is loose (tighten); 10. The laser current intensity must reach 8mA; 11 Laser aging (replacement: no charge during warranty period).