Modification of 100MW laser pointer
A lot of times the result is very light, because the aircraft still has at least 200 km/h speed in LAndean's bow green laser pointer flight, and you correctly say you have to hit it exactly - i.e. in the eye. But if you do something similar and get caught, you will at least be fined without harming the pilot. This was an attempt to cause physical harm and dangerous interference with air traffic - even though the aircraft was actually landing on its own. Even a 5 euro laser pointer can do the trick. A normal light can do this too, if it's bright enough and you can't see it properly for a few minutes. A burning laser is a laser that produces enough energy to actually burn something, used to do things like burn light, light paper, and possibly even penetrate objects, such as B. Burn rope or thin plastic. These are usually hand-held and are considered as potentially harmful as weapons. While standard rifle laser Pointers should not be aimed at living things, especially in the eyes of humans or animals, this will also hit the burning laser. Even a brief interaction between someone's eye and the laser can easily cause permanent retinal damage that can lead to blindness.
Tags
Technology
The basic process required to modify a 100MW laser pointer in this way is to open the pen's case and remove the laser diode and the small circuit board attached to it. When doing this, components can easily break and must be done with great care and patience. After removing the diode and circuit board, the resistor on the circuit board may be damaged by heat from a soldering iron or similar heat source. The high powered laser are then reassembled and will effectively become burning lasers, because the power in the diode will be greater and the laser will generate heat.
2021-12-14 11:11:02
Your Answer: