Must Be Initialized After Bouncing Green Laser Pointer
If there is an alarm, the device will automatically switch to the suspended state. And the reset button will flash at a frequency of 0.2s. At the same time, the buzzer will beep at a frequency of 1s and the tri-color light is always red. Press the alarm reset button to reset the alarm after the related alarm is resolved, and then press the start button to continue the operation. When the laser welding is wrong, press the emergency button in time. Stop button, the system will automatically cut off the laser control. Power for each servo motor. Prevent accidents. The green laser pointer must be initialized after the emergency stop pops up.
Tags
Technology
The whole machine resets the alarm. The green laser pointer welding machine can only be operated after the top cover is pre-welded. Limit alarm: indicates that the motor has reached the soft limit and can only run in the opposite direction without resetting; axis ALM alarm: only need to reset the axis alarm or press the alarm reset button in the function window; when the laser is not controlled during operation , You need to quickly press the emergency stop button. Pressing the emergency stop will stop sending the laser signal and power off the welding shaft. After handling the fault, pop up the emergency stop button. Reset the top laser pre-welding green laser pointer welding machine and reset the program.
2020-03-16 03:17:43
Your Answer: